Climatech, formerly Betlyn’s Heating (at least their location in Moon Twp., PA), got the job done quickly and neatly, I have no complaints on that front. Paul Betlyn, the former owner of the company, really is a great guy and it’s because he helped us out last Summer that we called him when our system stopped working this past week in February. The repair was going to be far more than one would want to pay based on the cost of an entirely new system, and since we were at 22 years old with the current one, we decided to move forward with both a new furnace and AC. Paul measured everything, quoted us the full cost, and even gave us a space heater until they could get here just two days later…really was a great experience. My only complaint about the entire process came after everything was installed and the techs had left. Paul’s quote had a line for a “programmable/non-programmable thermostat and ALL CONTROL WIRING” and the way he filled it out was he crossed out what wasn’t being done and left the things that were to be done without lines through them on the paper. He crossed out the need for a thermostat but left the “All Control Wiring” part there. We assumed this meant they would handle new thermostat wiring because when Paul was out the previous summer to fix our situation, we determined that the yellow and white wires were shorting/touching together somewhere along the run and we ended up needing to use our blue/C wire as the new W. Well unfortunately, we didn’t get new wiring. The techs ran a new 8 conductor wire from the furnace and spliced it into the old above the ductwork in our furnace room (to the 4 that had been used at the tstat), which gave me the feeling they were trying to make it look a certain way, but I won’t jump to any conclusions there. When I inquired about this, I was told by another tech that called the next day to address my concerns that it would be an additional charge for him to actually run new wiring. Not only that, he told me he’d be back to do it the following day and now we’re at two days later and I haven’t heard a word. Long story short, I ended up running the new wiring myself because I didn’t want any power stealing happening between my Nest and my new system and wasn’t going to wait any longer. Fast forward 2 weeks and I’ve also come to notice that none of the 4 techs made any effort to properly set the 1st dip switch on the control board to account for timed second stage heating due to lack of a W2 wire. So they sell and install 2-stage furnaces but aren’t necessarily setting that aspect up to work. Mine was set as though I DID have the W2 connected at both ends. Luckily, I’ve also remedied this by attaching my free brown wire on both ends to W2. I may not often need two stage heating but that’s what I paid for and I want to know it’s going to work when necessary! Aside from these minor misunderstandings/shortfalls, I highly recommend Betlyn’s/Climatech and feel Paul Betlyn is one of the last few amazing HVAC guys out there (we’ve been very much ripped off in the past before we found him). If you need a new setup or someone with a wealth of knowledge to troubleshoot, call him first and then every time after that!

Climatech and installer Lou were fantastic. From the initial quote to installation they followed through on everything that was promised. Arrived on time, professional and efficient during installation. Surpassed expectations. They installed a range hood, a range hood vent that required significant modification and cleaned my ductless Mitsubishi units. Everything works perfectly. Highly recommend.